Saturday, May 18, 2013

Requirements and Functions of Substation Automation


Introduction

Substation automation is the cutting edge technology in electrical engineering. It means having anintelligentinteractive power distribution network including :
  1. Increased performance and reliability of electrical protection.
  2. Advanced disturbance and event recording capabilities, aiding in detailed electrical fault analysis.
  3. Display of real time substation information in a control center.
  4. Remote switching and advanced supervisory control.
  5. Increased integrity and safety of the electrical power network including advanced interlocking functions.
  6. Advanced automation functions like intelligent load-shedding.

Requirements

The general requirements for selecting an automation system while designing a new substation are:
  1. The system should be adaptable to any vendor’s hardware.
  2. It should incorporate distributed architecture to minimize wiring.
  3. It should be flexible and easily set up by the user.
  4. The substation unit should include a computer to store data and pre-process information.

Functioning

Bus voltages and frequencies, line loading, transformer loading, power factor, real and reactive power flow, temperature, etc. are the basic variables related with substation control and instrumentation. The various supervision, control and protection functions are performed in the substation control room.
The relays, protection and control panels are installed in the controlled room. These panels along with PC aids in automatic operation of various circuit breakers, tap changers, autoreclosers, sectionalizing switches and other devices during faults and abnormal conditions.
Thus, primary control in substation is of two categories:
  1. Normal routine operation by operator’s command with the aid of analog and digital control system.
  2. Automatic operation by action of protective relays , control systems and PC.
The automated substation functioning can be treated as integration of two subsystems, as discussed below :

Requirements and Functions of Substation Automation (a) Control System

The task of control system in a substation includes data collection, scanning, event reporting and recording; voltage control, power control, frequency control, other automatic and semiautomatic controls etc.
The various switching actions like auto reclosing of line circuit breakers, operation of sectionalizing switches, on-load tap changers are performed by remote command from control room. The other sequential operations like load transfer from one bus to another, load shedding etc. are also taken care by control center.

(b) Protective System

The task of protective system includes sensing abnormal condition, annunciation of abnormal condition, alarm, automatic tripping, back-up protection, protective signaling.
The above two systems work in close co-operation with each other. Most of the above functions i.e. automatic switching sequences, sequential event recording, compiling of energy and other reports, etc. are integrated in software in the substation computer. This software is of modular design, which facilitates addition of new functions.
The communication between circuit breakersautoreclosers and sectionalizing switches in the primary and secondary distribution circuits located in the field and the PC in distribution substation control room is through radio telecontrol or fibre optic channel or power line carrier channel as is feasible.

No comments:

Post a Comment